Engineering, 21.01.2021 21:50 hairj9888
An aluminum bar 125 mm long with a square cross section 16 mm on an edge is pulled in tension with a load of 66,700 N and experiences an elongation of 0.43 mm. Assuming that the deformation is entirely elastic, calculate the modulus of elasticity of the aluminum. (Please leave a space between the number and the unit, and use correct capitalization and lower case for units - for example: MPa, not Mpa.)
Answers: 1
Other questions on the subject: Engineering
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 03.07.2019 15:10, theamandawhite
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
An aluminum bar 125 mm long with a square cross section 16 mm on an edge is pulled in tension with a...
Questions in other subjects:
Mathematics, 19.03.2020 02:38
