Engineering, 21.01.2021 05:20 joytheqt

Achieve a given revised spec The customer has a LED circuit box with the following configurations. An op-amp, a 1.5V
input battery, a iko input resistor and a 2kg feedback resistor It is used to light up a 1.2
to ZV LED with a 1000 resistor connected in series at output terminal "a" and "b".
Now the customer would like to use this box to operate with a total number of 6 different
changing the value of one of the components
colours of LEDs to make a light chain (6 LEDs connected in series) and place it in his office
reception. The output terminal voltage shall be increased to +12V. One more condition,
the company would like to have the circuit as simple as possible.
Note: An internal 15V battery pack is installed in the op-amp and so you do not need to
consider the power supply to the op-amp in your design.
t-
1.5V
100
b.
1. Briefly describe your design circuit which satisfying customer's requirement
(show your calculations if any) and how it works.
please help me

Achieve a given revised spec

The customer has a LED circuit box with the following configurations

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, danksans7011

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 19:10, rayne40

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

continue

You know the right answer?

Achieve a given revised spec The customer has a LED circuit box with the following configurations....