Engineering, 19.01.2021 18:50 natalie2sheffield

A vertical piston/cylinder device contains 0.01 lbm of gas. The gas has an initial volume of 0.18 ft3 and initial specific internal energy of 282 Btu/lbm. The piston, with a mass of 110 lbm and cross-sectional area of 0.11 ft2 , is in equillibrium with the gas. The outside ambient pressure is 14.7 psia. The gas now undergoes a process in which the volume increases to 0.4 ft3 . The final specific internal energy is 316 Btu/lbm. Assume a quasi-equillibrium process in which piston movement is slow with no acceleration. Friction between the piston and cylinder is negligible. a. Determine work [Btu] during the process (magnitude and direction)
b. Determine heat transfer [Btu] during the process (magnitude and direction)

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, mirmir62

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

You know the right answer?

A vertical piston/cylinder device contains 0.01 lbm of gas. The gas has an initial volume of 0.18 ft...