Engineering, 18.01.2021 14:00 gbrightwell

Configuring an Active Directory Domain Controller 1.Why would an administrator want to use the MAP Toolkit?
2.Based on the results of the MAP inventory you performed in the lab, which operating system was installed on the TargetWindows02b server?
3.Based on the results of the MAP inventory you performed in the lab, which desktop and server software was installed on the TargetWindows02b server?
4.Which tasks, other than the ones performed in this exercise, can administrators use the MAP Toolkit to perform?
5.Which utility is used to transform a standalone Windows Server 2012 R2 system into an Active Directory domain controller?
6.What is the importance of when using PowerShell to install and configure Active Directory?
7.What considerations should you take into account when choosing a domain name?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, salazjlove

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

continue

Engineering, 04.07.2019 18:20, alexis9263

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

You know the right answer?

Configuring an Active Directory Domain Controller 1.Why would an administrator want to use the MAP...