subject
Engineering, 15.01.2021 19:40 sierrac2651

Responsible drivers asses their personal fitness to drive before getting behind the wheel. Discuss 3 questions you should ask yourself when assessing your fitness and explain how your answers determine your fitness yo drive

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 19:20, kaitlyn114433
Ashielded metal arc-welding operation is accomplished in a work cell by a fitter and a welder. the fitter takes 5.5 min to load components into the welding fixture at the beginning of the work cycle, and 1.5 min to unload the completed weldment at the end of the cycle. the total ength of the weld seams 1200 mm, and the travel speed used by the welder averages 300 mm/min. every 600 mm of seam length, the welding stick must be changed, which takes 0.8 min. while the fitter is working, the welder is idle (resting): and while the welder is working the fitter is idle. (a) determine the average arc-on time as a fraction of the work cycle time. (b) how much improvement in arc-on time would result if the welder used flux-cored arc welding (manually operated), given that the spool of weld wire must be changed every 10 weldments, and it takes the welder 5.0 min to accomplish the change? (c) what are the production rates for these two cases (weldments completed per hour)? attach your work and solutions.
Answers: 1
image
Engineering, 06.07.2019 02:30, emiller6462
Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers
Answers: 3
image
Engineering, 06.07.2019 04:10, nickmoose04
Aheat pump with refrigerant-134a as the working fluid is used to keep a space at 25°c by absorbing heat from geothermal water that enters the evaporator at 500c at a rate of 0.065 kg/s and leaves at 40°c. the refrigerant enters the evaporator at 20°c with a quality of 23 percent and leaves at the inlet pressure as saturated vapor. the refrigerant loses 300 w of heat to the surroundings as it flows through the compressor and the refrigerant leaves the compressor at 1.4 mpa at the same entropy as the inlet. determine: (a) the degrees of subcooling of the refrigerant in the condenser, b)-the mass flow rate of the refrigerant . (c) the heating load and the cop of the pump, and d)-the theoretical minimum power input to the compressor for the same heating load.
Answers: 3
image
Engineering, 06.07.2019 05:10, suicune19
Apipe of diameter 200 mm (constant) carrying water with an 5 mis and total head is density 1000 kg/m ) with velocity tpward slope. at a certain point, where the elevation is 5 m above a datum, the 21.5 m. a) determine the pressure of the pipe at 5m elevation. determine the pressure at elevation 10m (above same datum) if the of total head at 5m elevation.
Answers: 1
You know the right answer?
Responsible drivers asses their personal fitness to drive before getting behind the wheel. Discuss 3...

Questions in other subjects:

Konu
History, 22.09.2019 13:50
Konu
English, 22.09.2019 13:50
Konu
Health, 22.09.2019 13:50