Engineering, 14.01.2021 21:00 andrewmena05

ANSWER EACH QUESTION PL 3. A jar made of 3/16 inch thick glass has an inside radius of 3.00 inches and total height of 6.00 inches (including the bottom thickness of glass). The glass has a density of 165 lb/ft3. The jar is placed in water with a density of 62.5 lb/ft3.

a. Assume the jar sits upright in the water without tipping over. How far will the empty jar sink into the water?
i. What is the volume of the glass shell of the jar? Precision 0.00

ii. What is the weight of the jar? Precision 0.00

iii. What is the weight of water the empty jar will displace? Precision 0.00

iv. What is the volume of water the empty jar will displace? Precision 0.00

v. How far will the empty jar sink?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 03:10, lauriepdx17

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

continue

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

You know the right answer?

ANSWER EACH QUESTION PL 3. A jar made of 3/16 inch thick glass has an inside radius of 3.00 inches...