Engineering, 13.01.2021 23:10 cammiehullett2610

A cable is attached to a 2.00 kg block A, is looped over a fixed peg at C, and is attached to plate B. The coefficient of static friction between the plate and the block is 0.260, the coefficient of static friction between the plate and the inclined plane is
0.330, and the coefficient of static friction between the cable and the peg is 0.430. If the plane's angle is 30.0 degrees, what is the
maximum mass that plate B can have such that it does not slide down the plane?

A cable is attached to a 2.00 kg block A, is looped over a fixed peg at C, and is attached to plate

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, siri5645

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Engineering, 04.07.2019 19:10, gabigalvis1091

What is the main objective of using reheat rankine cycle?

Answers: 3

continue

You know the right answer?

A cable is attached to a 2.00 kg block A, is looped over a fixed peg at C, and is attached to plate...