subject
Engineering, 08.01.2021 17:40 indiaseel2744

A centrifugal pump is installed in a pipeline to raise water14.9 m into an elevated holding tank. The length of the ductileiron pipeline (f=0.019) connecting the reservoirs is 22.4 m. Thepipe is 5.0 cm in diameter and the performance curve of the pump isgiven by Hp =23.9?7.59Q2 where Hp is in meters, Q is in liters persecond, and the equation is valid for flows up to 1.5 L/s. Usingthis pump, what flow do you expect in the pipeline if minor lossesare ignored? What pump head is required for this flow?

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
image
Engineering, 04.07.2019 18:10, ayoismeisjjjjuan
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
image
Engineering, 04.07.2019 19:20, jimena15
The quality is zero at a)-the saturated vapour state b)-the saturated liquid state c)-the saturated liquid-vapour mixture state d)-none of the states in the other answers
Answers: 3
image
Engineering, 04.07.2019 19:20, mercedesamatap21hx0
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
You know the right answer?
A centrifugal pump is installed in a pipeline to raise water14.9 m into an elevated holding tank. Th...

Questions in other subjects:

Konu
Physics, 04.06.2020 19:57