Engineering, 31.12.2020 18:10 ggpro4life3000

A hollow steel tube has a diameter of 300 mm, wall thickness of 20 mm and a length of 500 mm. A slot 20 mm wide is machined through the wall thickness and along the whole length of the
tube. The tube is positioned on a rigid horizontal surface with the slot at one extreme of a
horizontal diameter. A force W is then applied on the upper surface along the vertical diameter
and uniformly along the length of the tube. Calculate the magnitude of this force which is
necessary to just close the slot

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, kayabwaller4589

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:20, cristykianpour

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

continue

Engineering, 04.07.2019 18:20, sanchez626

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

continue

You know the right answer?

A hollow steel tube has a diameter of 300 mm, wall thickness of 20 mm and a length of 500 mm. A slo...