Engineering, 27.12.2020 15:50 emmagossett2002
Oil at a mass flow rate of 15,000 lbm/hr is heated in a heat exchanger from 800F to 2050F. The heat capacity of the oil can be assumed constant at 0.49 BTU/lbm-0F. The oil flows through the inside of the tubes (1.0-in. inside diameter and combined length of 400 ft). The required heat is supplied by saturated steam condensing on the outside of the tubes, keeping the temperature of the inside surface of the tubes at a constant value of 2150F.
Calculate:
a. The total rate of heat transfer, in BTU/hr.
b. The total surface area for heat transfer, in ft^2.
c. The logarithmic mean temperature difference, in 0°F.
d. The heat-transfer coefficient based on the logarithmic mean temperature difference, in BTU/hr-ft^2-0F.
Answers: 3
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, cowgyrlup124
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 04.07.2019 18:10, settasav9641
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:20, 21megoplin
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
Engineering, 04.07.2019 19:10, thawkins79
Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj
Answers: 2
You know the right answer?
Oil at a mass flow rate of 15,000 lbm/hr is heated in a heat exchanger from 800F to 2050F. The heat...
Questions in other subjects:
Mathematics, 11.11.2021 14:00
