Engineering, 27.12.2020 04:30 onegirl435

Two technicians are discussing how to loosen bleeder valves. Technician A says that a shock is usually necessary to break the taper at the base of the valve. Technician B says to apply steady, loosening torque to the bleeder valve using a 6-point wrench. Which technician is correct

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:20, DroctorWellsfan

Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above

Answers: 1

continue

Engineering, 04.07.2019 18:20, karatsgrande3772

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

continue

Engineering, 04.07.2019 19:10, gabigalvis1091

What is the main objective of using reheat rankine cycle?

Answers: 3

continue

You know the right answer?

Two technicians are discussing how to loosen bleeder valves. Technician A says that a shock is usual...