Engineering, 14.12.2020 07:30 sherry59Sherry59
Why is sand used as a bed for melting of metal in Cupola furnace?
Answers: 3
Engineering, 05.07.2019 23:20, neisha2507
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
Engineering, 06.07.2019 02:30, Nonniel0v3
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
Engineering, 06.07.2019 04:10, jessicajustice6215
Cold water (cp=4180j/kg k) leadıng to a shower enters a thin-walled double-pipe heat transfer at 15c at a rate of 0.25kg/s and is heated to 45c by hot water (cp=4190j/kg k) that enters at 100c at the rate of 3kg/s. if the overall heat transfer coefficient is 950w /m2 k , determıne the rate of heat transfer and the heat transfer surface area of the heat exchanger using e - ntu method
Answers: 1
Engineering, 06.07.2019 04:30, BARRION1981
Mention three advantages and two disadvantages of cmm.
Answers: 1
Why is sand used as a bed for melting of metal in Cupola furnace?...
Mathematics, 22.05.2021 05:10
Law, 22.05.2021 05:10
Biology, 22.05.2021 05:10
Mathematics, 22.05.2021 05:10
Mathematics, 22.05.2021 05:10