Engineering, 11.12.2020 01:00 mjstew00763

Define a separate subroutine for each of the following tasks respectively. A) Swap the most significant bit (msb) of registered AH And the Least significant Bit (Lsb) of registered AL.

B) Check the msb of AL and LSB of BL. if they are equal, copy BL into AL. Otherwise copy AL in BL

C) set all the bits in LS Nibble and Invert All bits in the MS nibble of the word at offset address 0400H in the data segment.

D) multiply the byte at offset address 0100h with the byte at offset address 0200h. save the result at offset address 0300h in the data segment.

pls answer i took hours to write these

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, kayabwaller4589

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

You know the right answer?

Define a separate subroutine for each of the following tasks respectively. A) Swap the most signifi...