Engineering, 10.12.2020 18:40 amandafutch24

Linear dimensioning commands are used to dimension . horizontal and vertical lines

notes

arcs

circles

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

You know the right answer?

Linear dimensioning commands are used to dimension . horizontal and vertical lines

note...