Engineering, 05.12.2020 20:10 kkeith121p6ujlt

Im doing ths bc im rlly bored. heres my dream guy not h o m o p h o b i c/ t r a n s p h o b i c
f e m i n i ne
skates
has curly hair
wears rings
paints his nails
doesnt have t o x i c m a s c u l i n i t y \
doesnt think f e m i n i s m is g ay
doesnt think guys wearing dresses/skirts/croptops is g a y
doesnt support t r u m p
doesnt say th n word or any s l u r he is not allowed to say
suports blm
lol idk why i did this
I DIDNT DO THIS J TO GET A GUY LOL

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:20, 21megoplin

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Engineering, 04.07.2019 19:10, netflixacc0107

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

continue

You know the right answer?

Im doing ths bc im rlly bored. heres my dream guy not h o m o p h o b i c/ t r a n s p h o b i c