Engineering, 25.11.2020 14:40 0IggyMarie0

There is a mixing chamber connected with a valve. The chamber has two inlets and one exits. Liquid water at 200 kPa and 20 °C is heated in a chamber by mixing it with superheated steam at 200 kPa and 200 °C. Liquid water enters the mixing chamber at a rate of 2.5 kg/s, and the chamber is estimated to lose heat to the surrounding air at a rate of 1200 kJ/min. The mixture leaves the mixing chamber at 200 kPa and 70 °C. Assume steady state and ignore kinetic and potential energy effects. Assume there is no work or heat involved in the valve. Required:
a. If take the mixing chamber as the control volume, please list the simplified energy conservation equation for this CV.
b. If taking the mixing chamber and the valve as the combined control volume, please list the simplified energy conservation equation for this CV (leave it in symbolic form).
c. What is the mass flow rate at state 2?
d. There is a valve at the exit of the chamber to reduce the pressure to 20 kPa, determine the temperature at the exit of the valve

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, cowgyrlup124

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

continue

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

You know the right answer?

There is a mixing chamber connected with a valve. The chamber has two inlets and one exits. Liquid w...