Engineering, 25.11.2020 03:20 hetdashadia123

Awnser All for 100 points 1. Explain why cardan -type u-joints on a driveshaft must be within 1/2 a degree working angles?
2. What makes a constant velocity joint able to transmit engine torque through an angle at a constant velocity?
3. What type of grease must be used in CV joints?
4. Name two types of CV joints.
5. List two items that should be checked when inspecting a drivehaft.
6. List the steps necessary to measure driveshaft u-joint working angles.
7. Describe how to replace a cardan-type u-joint.
8. Explain the proper steps to perform when replacing a cv joint.
9. Explain how to determine a rear axle ratio without removing the housing cover.
10. Describe how to perform a ring gear tooth contact pattern test.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

You know the right answer?

Awnser All for 100 points 1. Explain why cardan -type u-joints on a driveshaft must be within 1/2...