Engineering, 24.11.2020 02:00 lewisf2578

A Boeing 777 landed at Chicago O’Hare Airport (668 m elevation) where the pressure is 98.8 kPa. Assume that the landing speed is 196.4 mi/hr. This 777 wing has a coefficient of drag of 0.034 and its wing area is 429.1 m2. What is the drag at the point where the aircraft just lands on the ground? Note that these conditions are non-standard so use altitude to calculate temperature then use the pressure given to calculate density.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

Engineering, 04.07.2019 18:10, jesuslovesusall3

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

continue

Engineering, 06.07.2019 03:20, carrietaylor234

Avertical steel rod of length 2.0 m and diameter 25 mm is rigidly fixed at its upper end and has a flange at its lower, free, end. what will be the maximum stress produced in the rod when a load of 20 kn is applied, (a) gradually to the lower end, (b) suddenly to the lower end, (c) by a collar falling from a height of 50 mm on to the flange?

Answers: 3

continue

You know the right answer?

A Boeing 777 landed at Chicago O’Hare Airport (668 m elevation) where the pressure is 98.8 kPa. Assu...