Engineering, 20.11.2020 21:30 savingmayo

If you guess what umber im thinking of i will give you 100 pts

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, ashleyjaslin

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

continue

Engineering, 04.07.2019 19:20, amandaaarmentaa

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

continue

Engineering, 06.07.2019 04:10, kathiewallentin1767

Steam enters a converging-diverging nozzle at 1.0 mpa and 500°c with a negligible velocity at a mass flow rate of 2.5 kg/s, and it exits at a pressure of 200 kpa. assuming the flow through the nozzle to be isentropic, determine: the exit area and (a) (b) the exit mach number

Answers: 2

continue

You know the right answer?

If you guess what umber im thinking of i will give you 100 pts...