Engineering, 20.11.2020 01:20 lizzynmk

Note: in the pictorial view, arrows pointing directly to a line are referencing a surface that is not visible, rather “around the back” of the object. Can you please help me?

Note: in the pictorial view, arrows pointing directly to a line are referencing a surface that is n

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Engineering, 04.07.2019 18:20, kendrawalraven

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

continue

Engineering, 04.07.2019 19:10, nhester3401

Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.

Answers: 2

continue

Engineering, 04.07.2019 19:20, rida10309

At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2

Answers: 2

continue

You know the right answer?

Note: in the pictorial view, arrows pointing directly to a line are referencing a surface that is no...