Engineering, 18.11.2020 17:30 itzyagirlshy

An element is subjected to plane stress. By rotating 20 degrees in the clockwise direction from its original position, the element can reach its principal stress state. Which rotation of the element from its original position can reach the state of maximum in-plane shear stress? a) 25 degrees in the counterclockwise direction
b) 70 degrees in the clockwise direction
c) 45 degrees in the clockwise direction
d) 45 degrees in the counterclockwise direction
e) 70 degrees in the counterclockwise direction
f) 25 degrees in the clockwise direction

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:20, karatsgrande3772

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

continue

Engineering, 04.07.2019 19:10, kelseiroll9759

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

continue

You know the right answer?

An element is subjected to plane stress. By rotating 20 degrees in the clockwise direction from its...