Engineering, 16.11.2020 17:00 zachzach28280

Explain why the t-distribution has less spread as the number of degrees of freedom increases. (A) The t-distribution has less spread as the degrees of freedom increase because, for large values of n, ngreater than or equals30, the t-distribution and the normal distribution are the same.

(B) The t-distribution has less spread as the degrees of freedom increase because, as n increases, less information is known about sigma by the law of large numbers.

(C) The t-distribution has less spread as the degrees of freedom increase because the variability introduced into the t-statistic becomes greater as n increases.

(D) The t-distribution has less spread as the degrees of freedom increase because, as n increases, s becomes closer to sigma by the law of large numbers.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 18:10, aaliyah80

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

continue

Engineering, 04.07.2019 18:10, QueenLife4869

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

You know the right answer?

Explain why the t-distribution has less spread as the number of degrees of freedom increases. (A) T...