subject
Engineering, 31.10.2020 05:10 DisneyGirl11

Designing a Solar Oven A science class has been assigned the task of developing a simple solar oven using a cardboard box as the base. The solar oven should be able to melt cheese for nachos, and the temperature should reach at least
140 °F. The total cost of the materials used must be less than $10 and the size of the oven must be 24” x 24” or less. The required temperature must be met within 60 minutes. The final outcome of the class project should be that the oven uses solar energy to make a plate of nachos, reaching the minimum temperature in the required amount of time.

The class used this design for its solar oven.

Which statements describe constraints that the science class’s solar oven must meet? Choose all of the correct responses.

A. It should use a box of some type.

B. It should be able to melt the cheese on the chips.

C. It must reach the given temperature within one hour.

D. The total cost of materials should be $10 or less.

E. It can be used by people in remote areas without access to electricity


Designing a Solar Oven

A science class has been assigned the task of developing a simple solar ov

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, settasav9641
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
image
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
image
Engineering, 04.07.2019 18:20, RiverH246
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
image
Engineering, 04.07.2019 18:20, rbgrh9465
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
Designing a Solar Oven A science class has been assigned the task of developing a simple solar oven...

Questions in other subjects: