Engineering, 30.10.2020 18:10 yesseniaroman21

(a)A three-point transverse bending test is conducted on a cylindrical specimen of aluminum oxide having a reported flexural strength of 300MPa (43,500psi). If the specimen radius is 5.0mm (0.20in.) and the support point separation distance is 15.0mm (0.61in.), would you expect the specimen to fracture when a load of 7500N (1690lbf) is applied? Justify your answer.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, winterblanco

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

You know the right answer?

(a)A three-point transverse bending test is conducted on a cylindrical specimen of aluminum oxide ha...