Engineering, 30.10.2020 17:40 Milan1025
An arc welding process is used to fillet weld a T-joint between two steel plates. The fillet weld has a cross sectional area of 160 mm2. The unit energy for melting Um is 10 J/mm3. The heat transfer and melting factors are 0.9 and 0.6, respectively. The arc welder can provide 5000 W of power. Calculate the travel speed in mm/sec. Answers are rounded to 2 decimal places
Answers: 3
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
Engineering, 06.07.2019 02:30, Nonniel0v3
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
You know the right answer?
An arc welding process is used to fillet weld a T-joint between two steel plates. The fillet weld ha...
Questions in other subjects:
Biology, 27.04.2021 16:00
Mathematics, 27.04.2021 16:00
