Engineering, 27.10.2020 17:20 cyni

A horizontal pipe (300 mm dia. And 300m length) leaves a reservoir of surface elevation 60 m at an elevation of 54 m. This pipe connects (abrupt contraction) to a 150 mm diameter pipe of length 300 m running to elevation 30 m, where it enters a reservoir of surface elevation 39 m. Assuming friction factor of 0.02, calculate the flowrate through the line.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 18:20, sanchez626

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

continue

Engineering, 04.07.2019 19:10, gabigalvis1091

What is the main objective of using reheat rankine cycle?

Answers: 3

continue

Engineering, 04.07.2019 19:10, jrcspiderman2003

Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?

Answers: 3

continue

You know the right answer?

A horizontal pipe (300 mm dia. And 300m length) leaves a reservoir of surface elevation 60 m at an e...