Engineering, 26.10.2020 17:30 hdbug2025
the diodes were ideal:a. What dc output voltage should the half-wave rectifier produce?b. What dc output voltage should the bridge rectifier produce?2.What is the peak reverse voltage impressed across the diode: a. In the half-wave rectifier with capacitor in parallel with the load resistor?b. In the bridge rectifier with capacitor in parallel with the load resist
Answers: 3
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:20, miguel454545
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
the diodes were ideal:a. What dc output voltage should the half-wave rectifier produce?b. What dc ou...
Social Studies, 05.09.2020 19:01
English, 05.09.2020 19:01