Engineering, 21.10.2020 16:01 asheeee58

: Consider a wing with a rectangular planform mounted in a low-speed subsonic wind tunnel. The wing model completely spans the test section so that it may be considered an infinite wing. If the wing has a NACA 4412 airfoil section (see textbook Appendix) and a chord of 0.4, calculate the lift, drag, and moment about the quarter-chord per unit span when the freestream air pressure is 98 kPa, the freestream temperature is 280 K, the freestream velocity is 38 m/s, and the viscosity is 1.7894 ∙ 10−5 kg/(m ∙ s) at the following angles of attack: a) 5° b) 16° c) -2

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, jadeochoa4466

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:20, cdyshaylia55

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

continue

You know the right answer?

: Consider a wing with a rectangular planform mounted in a low-speed subsonic wind tunnel. The wing...