subject
Engineering, 20.10.2020 20:01 philliple481

A pork-processing facility is considering installing either a storage facility or a holding pond. A biosystems engineer has been hired to evaluate the economic trade-offs for the two alternatives. The engineer estimates the cost of the storage facility to be $213,000, with annual costs for maintenance to be $3,200 per year. She estimates the cost of the pond to be $90,000, plus $45,000 for pumps and piping; annual operating and maintenance costs for the holding pond are estimated to be $8,500. The engineer estimates the life of the storage facility and the pond to be around 20 years but is concerned about the accuracy of this estimate. She decides to do a sensitivity analysis. Click here to access the TVM Factor Table Calculator
Develop the equation she should use to determine how sensitive the economic decision is to changes in life. Use a MARR of 15%
Equation that can be used to determine the sensitivity is
Determine which alternative is preferred for lives ranging from 15 to 25 years in 1 year increments:
Life Difference Preferred Alternative
15
16
17
18
19
20
21
22

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:20, karatsgrande3772
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
image
Engineering, 04.07.2019 18:20, samueltaye
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
A pork-processing facility is considering installing either a storage facility or a holding pond. A...

Questions in other subjects:

Konu
Mathematics, 05.09.2021 19:10
Konu
Mathematics, 05.09.2021 19:10