subject
Engineering, 17.10.2020 14:01 BakerElsie02

Assignment directions In this project, you will consider what to do with the C&D materials after a house is demolished. Read the EPA report “Analysis of the Life Cycle Impacts and Potential for Avoided Impacts Associated with Single-Family Homes” at epa. gov and answer the questions below.

Assignment guidelines
Part 1: Write a short introduction that defines life-cycle assessment, its phases, and what C&D materials are. Label it “Introduction.”

Part 2: Answers the following questions in complete paragraphs. Label this section “Analysis.” Number your answers 1 through 4:

1. What are some of the health and safety considerations for recycled or reused materials?
2. Do you think adherence to Life Cycle Assessment is good for the construction industry? Why or why not?
3. How is demolishing a house like building a house?
4. Which process appeals to you more: Building a house or demolishing a house? Explain your opinions.
Feel free to consult other resources for more information or to help you form an opinion. If you do, please list them in a Reference section with URLs if applicable.

Submission requirements
Submit your paper electronically. It should be 2 to 3 pages long. Sentences should be complete. Define your terms. Spelling, punctuation, and grammar count.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, viicborella
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, oshawn108
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k
Answers: 2
image
Engineering, 04.07.2019 19:10, jimena15
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
You know the right answer?
Assignment directions In this project, you will consider what to do with the C&D materials afte...

Questions in other subjects:

Konu
Mathematics, 07.01.2020 19:31