Engineering, 17.10.2020 03:01 Gyalissunout3526

A 7 in wide polyamide F1 flat belt is used to connect a 2-in diameter pulley to drive a larger pulley with an angular velocity ratio of 0.5. The center-to-center distance is 9 ft. The angular speed of the small pulley is 2000 rev/min as it delivers 2 hp. The service is such that a service factor of Ks of 1.25 is appropriate. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Find F Fi (F)a and 2 assuming operation at the maximum tension limit. (You must provide an answer before moving to the next part) The value of Fis Ibf. The value of F is| Ibf. The value of (Fa is Ibf. The value of F2 is

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

Engineering, 04.07.2019 18:10, mirmir62

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

continue

Engineering, 04.07.2019 19:20, amandaaarmentaa

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

continue

You know the right answer?

A 7 in wide polyamide F1 flat belt is used to connect a 2-in diameter pulley to drive a larger pulle...