Engineering, 16.10.2020 14:01 bigboy43

A horizontal structure consists of an 10-mm-thick layer of copper and an 10-mm-thick layer of aluminum. The bottom surface of the composite structure receives a heat flux of 100 kW/m^2, while the top surface is exposed to convective conditions characterized by h= 40 W/m^2·K, T[infinity] =25°C. The initial temperature of both materials is Ti, A = Ti, B=25°C, and a contact resistance of 200 × 10^−6 m^2·K/W exists at the interface between the two materials. Required:
a. Determine the times, both in seconds, at which the copper and aluminum each reach a temperature of 90°C. The copper layer is on the bottom.
b. Repeat part (a) with the copper layer on the top.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

You know the right answer?

A horizontal structure consists of an 10-mm-thick layer of copper and an 10-mm-thick layer of alumin...