subject
Engineering, 16.10.2020 20:01 dogeking12

In the action adventure film Indiana Jones and the Raiders of the Lost Ark, Indiana Jones searches for the Ark of the Covenant. In one well-known nail biting scene Indiana tries to escape being crushed by a huge boulder rolling down a sloping terrain inside a tunnel. The rolling boulder of mass m rolls down the only path that Indiana Jones can take. Assume that the friction force between the sphere and the surface of the hill is negligible. At a particular time t1 the spherical boulder is at location 1 and moving with velocity v1. At a later time t2 the sphere is at location 2 and moving with velocity v2. Locations 1 and 2 are at vertical heights h1 and h2 respectively, from the bottom of the tunnel. When answering the following questions use 1 and 2 for subscripts to identify the different variables at the two different locations.

Part (a): U1 = mgh1
Part (b): What is the equation for translational kenetic energy, KT,1 of the spherical boulder?

KT,1 = .5mv12
Part (c): What is the equation for the rotational kinetic energy KR,1of the spherical boulder?
KR,1 = .5w12 ; KR,1 = (1/5)mv12

Part (d): What is the equation for the total kinetic energy Ktotal,1of the spherical boulder in terms of its linear speed?
Ktotal,1 = (7/10)mv12

Required:
Write the mathematical equation for the conservation of mechanical energy in terms of the mass, velocity, height and g.

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, oliviasoreo92
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
image
Engineering, 04.07.2019 18:20, ashleyjaslin
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
image
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
You know the right answer?
In the action adventure film Indiana Jones and the Raiders of the Lost Ark, Indiana Jones searches f...

Questions in other subjects:

Konu
Biology, 23.06.2019 21:00
Konu
Mathematics, 23.06.2019 21:00
Konu
Mathematics, 23.06.2019 21:00
Konu
Physics, 23.06.2019 21:00