Engineering, 15.10.2020 08:01 elijahjacksonrp6z2o7

Aluminum is being cast into a cylindrical mold which is 3 cm high and has a diameter of 1.5 cm. The cylinder is upright in the mold. The mold is bottom gated. There is a vent on the top of this part which extends to the top of the mold, but is so thin that no liquid metal can enter it. You wish to fill the part with no aspiration. The pouring basin is 2 cm tall and is completely filled during pouring. The height from the top of the pouring basin to the bottom of the part is 8 cm. The sprue is conical; the grate and runner are cylindrica. Assuming the bottom of the sprue and the gate have the same diameter, determine: a. diameter of the gate
b. diameter of the top of the sprue
c. the filling time of the mold.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, DroctorWellsfan

Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above

Answers: 1

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Engineering, 06.07.2019 03:30, aminsaad4253

Abrayton cycle operates with a regenerator on the air-standard with properties evaluated at 400 k. the tem- perature of the air entering the compressor is 350k while the temperature of the air exiting the compressor is 600 k. the temperature of the air entering the turbine is 1600 k. the overall cycle produced 600 kj/kg of net work out. assuming a regenerator effectiveness of 0.8, what is the temperature of the air before heat addition (combustion)? draw this process on a t - s diagram

Answers: 3

continue

Engineering, 06.07.2019 04:10, makenziemartinez

Aheat pump using refrigerant-134a heats a house by using underground water at 8°c as the heat source. the house is losing heat at a rate of 60,000 kj/h. the refrigerant enters the compressor at 280 kpa and 0°c, and it leaves at 1 mpa and 60°c. the refrigerant exits the condenser at 30°c. determine: (a) the power input to the heat pump, (b) the rate of heat absorption from the water, and (c) the increase in electric power input if an electric resistance heater is used instead of a heat pump

Answers: 2

continue

You know the right answer?

Aluminum is being cast into a cylindrical mold which is 3 cm high and has a diameter of 1.5 cm. The...