Engineering, 13.10.2020 08:01 aaliyah80

Which of the following is NOT an acceptable practice for using an engineering notebook? A Pasting in sketches with glue
B Numbering pages
C Writing in pen
D Writing the date at the top of each entry
E Scribbling out mistakes so they are completely covered in ink

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, bunnles

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

continue

Engineering, 06.07.2019 03:20, demotte79991

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

continue

Engineering, 06.07.2019 04:10, kraigstlistt

Agas mixture with a compostion of 55 methane, 30% propane, and 15 butane by volume) is compressed from 1 bar and 25°c to 9bar in a compressor with an isentropic efficiency of 85%. the environment has a temperature of to25 c. determine (a) the exit temperature of the mixture (b) the specific work required to run the compressor (c) the specific entropy generation of the process (d) the specific exergy destruction of the process (e) the second law efficiency of the compressor

Answers: 3

continue

You know the right answer?

Which of the following is NOT an acceptable practice for using an engineering notebook? A Pasting i...