Engineering, 08.10.2020 09:01 janreyes39

As an automation engineer, you are asked to design a control system at a hydroelectric water dam to control the amount of water flow to the turbine of electricity generator to achieve the desired turbine rotation speed. (a) Using the information of sensors and actuators given in the Chapter 6 course lectures, suggest and describe what are the appropriate sensors and actuators to be used to achieve the desired turbine rotation speed. Include a justification about your selections of sensors and actuators for the control system. (b) Also discuss what types of input/output signals will be needed in the control system and how the system is to utilize the input/output data. g

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

You know the right answer?

As an automation engineer, you are asked to design a control system at a hydroelectric water dam to...