Engineering, 02.10.2020 09:01 gggggggggggg5496

A student is measuring the effects of an electric circuit on a compass, and he is testing to see if increasing the current will cause the compass needle to change its direction faster. He does one trial using a 9-volt battery and another trial using a 1.5-volt battery. He takes accurate data. Based on good experimental design, what would improve his experiment? A) He should repeat the test with three additional batteries of varying voltages to demonstrate the reproducibility of results.

B) He should use only one battery but do several trials, using different circuit designs to ensure he has appropriate test groups.

C) He should add a nonworking compass to act as a control.

D) He should use batteries of the same voltage but from different manufacturers to show he has used different variables.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, aliceohern

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

You know the right answer?

A student is measuring the effects of an electric circuit on a compass, and he is testing to see if...