Engineering, 02.10.2020 09:01 bellapearl163
Where is it recommended to have a higher mesh density? Mark all that apply
Nowhere, the mesh should be uniform density throughout
Regions where a higher degree of accuracy is desired
Regions with large gradients in the primary variable
Regions of complex geometry
Answers: 3
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Where is it recommended to have a higher mesh density? Mark all that apply
Nowhere, the mesh should...
Mathematics, 23.07.2020 02:01
Mathematics, 23.07.2020 02:01