Engineering, 25.09.2020 03:01 jespinozagarcia805

Given asphalt content test data: a. Calculate the overall mean and standard deviation for the entire test period.
b. The contract specifications require an average asphalt content of 5.5% +/-0.5% every day Plot the daily average asphalt content. Show upper and lower control limits
c. Do all of these samples meet the contract specifications? Explain your answer
d. What trend do you observe based on the data? What could cause this trend?
Date Sample Number Asphalt Content %
5-May 1 5.5
5-May 2 5.8
6-May 3 5.3
6-May 4 5.4
7-May 5 5.7
7-May 6 5.7
8-May 7 5.6
8-May 8 5.8
9-May 9 5.4
9-May 10 5.5
12-May 11 5.3
12-May 12 5.6
13-May 13 5.8
13-Ma 14 5.1
14-May 15 5.8
14-May 16 5.9
15-May 17 5.1
15-May 18 5.2
16-May 19 5.2
16-May 20 4.8

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

Engineering, 04.07.2019 19:20, dndndndnxmnc

The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal

Answers: 3

continue

Engineering, 04.07.2019 19:20, mads000

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

continue

You know the right answer?

Given asphalt content test data: a. Calculate the overall mean and standard deviation for the entir...