Engineering, 24.09.2020 22:01 kuddlebugsmommy

Consider a pair of standard, 20° pressure angle steel gears with a .75 inch face width. The pitch diameter of the pinion is 2.00 inches. The pitch diameter of the mating gear is 6.00 inches. The gears are made from a grade of steel which exhibits an ultimate tensile strength of 120,000 psi. and which has been case hardened such that the ultimate tensile strength of the tooth surfaces is 180,000 psi. What range of values of gear pitch will result in the maximum capacity (i. e. torque or power at a specified speed) of the gear pair? You may assume values for unknown parameters which you believe are typical of industrial machinery but do not make unnecessary assumptions. Please be explicit about all assumptions and justify as appropriate.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Engineering, 04.07.2019 18:20, RiverH246

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

You know the right answer?

Consider a pair of standard, 20° pressure angle steel gears with a .75 inch face width. The pitch di...