subject
Engineering, 24.09.2020 15:01 luv4appleallday

The use of seat belts in cars has significantly reduced the number of crash fatalities. Which statement best explains how the market forces of supply and demand guided the development of seat-belt technology? A. When a large enough supply of seat-belt parts became available, the public demand for their use in cars increased.B. Consumers' desire for more comfortable seat belts led engineers to improve seat belts.C. Engineers recognized the dangers of not wearing a seat belt and decided to develop systems that would be affordable to manufacture.D. As car manufacturers developed seat-belt technology, they began to advertise seat belts' ability to prevent injuries and death to consumers.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, salazjlove
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
image
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
image
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
You know the right answer?
The use of seat belts in cars has significantly reduced the number of crash fatalities. Which statem...

Questions in other subjects: