A steady‐flow gas furnace supplies hot air at a rate of 850 cfm and conditions of 120F and 1.00 atm. The air splits into two branches: a 10" diameter duct and a 12" diameter duct. The velocity in the 12" diameter duct is 800 ft/min. Determine:
(a) The volumetric flow in the 12"‐dia. duct.
(b) The velocity in the 10"‐dia. duct.
(c) The volumetric flow rate into the furnace if the air enters at 68F and 1.00 atm.
(d) The mass flow rate of air entering the furnace.

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k