Engineering, 22.09.2020 23:01 pindu
n a switching converter, the switching power loss in a MOSFET is 100 Watts. The lead engineer decides to redesign this converter and replace the original MOSFET with a new one that has twice the switching speed, this, it has one-half the voltage and current rise-time and fall-time compared to the original MOSFET. This new converter is to be operated at twice the switching frequency compared to the original converter. Question: What happens to the switching power loss in the MOSFET of the new converter, compared to that in the original converter?
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10, wirchakethan23
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
You know the right answer?
n a switching converter, the switching power loss in a MOSFET is 100 Watts. The lead engineer decide...
Questions in other subjects:
History, 10.12.2019 09:31
Mathematics, 10.12.2019 09:31
History, 10.12.2019 09:31
Chemistry, 10.12.2019 09:31
