subject
Engineering, 21.09.2020 23:01 alphaaz23415

Strawberries contain about 15 wt% solids and 85 wt% water. To make strawberry jam, crushed strawberries and sugar are mixed in a 45:55 mass ratio, and the mixture is heated to evaporate water until the residue contains one-third water by mass. a) Draw and label a flowchart of this process.
b) Do the degree-of-freedom analysis and show that the system has zero degrees of freedom (i. e., the number of unknown process variables equals the number of equations relating them). If you have too many unknowns, think about what you might have forgotten to do.
c) Calculate how many pounds of strawberries are needed to make a pound of jam.
d) Making a pound of jam is something you could accomplish in your own kitchen (or maybe even a dorm room). However, a typical manufacturing line for jam might produce 1500lbm/h1500lb m/h. List technical and economic factors you would have to take into account as you scaled up this process from your kitchen to a commercial operation.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, breannaasmith1122
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
image
Engineering, 04.07.2019 18:10, sarahgrindstaff123
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
image
Engineering, 04.07.2019 18:20, luisgonz5050
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
You know the right answer?
Strawberries contain about 15 wt% solids and 85 wt% water. To make strawberry jam, crushed strawberr...

Questions in other subjects:

Konu
Biology, 30.03.2021 05:00
Konu
Mathematics, 30.03.2021 05:00
Konu
Social Studies, 30.03.2021 05:00