Engineering, 21.09.2020 14:01 pluto82

As the junior engineer at the Mesabi Range Hydraulic Engineering Company located in Ely, Minnesota, you have been tasked with designing a new irrigation canal that will be used by the English Pea Farmers Cooperative of Northern Minnesota. The canal will run from Basswood Lake to the pea fields located just south of town. The canal is to be 22 miles in length, unlined, excavated in stiff clay and must handle a flow rate of 13.15 m3/s over a slope of 0.2%. Your Boss wants you to calculate the necessary canal parameters and to also determine if the canal will fit within the 85-foot wide right-of-way established by the Lake County land-use office

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:20, mjcbs21

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

continue

Engineering, 04.07.2019 19:10, gabrielaperezcz

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

continue

Engineering, 04.07.2019 19:10, nida7864

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

continue

You know the right answer?

As the junior engineer at the Mesabi Range Hydraulic Engineering Company located in Ely, Minnesota,...