Engineering, 20.09.2020 09:01 igotdiss2178

A steel spur gear and mating pinion similar to those you have seen in class have 67 and 24 teeth respectively. The pitch, P, is 12 and the pressure angle is 20°. The face width is 7/8 inch. The gears are to be used in conveyer drive. The gears operate continuously with a pinion speed of 1760 rpm. They must be 99% reliable over a period of 2 years while continuously transmitting 6 hp. In this application we know or assume: • The gears are machined.
• The velocity factor can be determined from Curve D in Figure 15.24 in J&M.
• The power source (electric motor) is uniform.
• The load is uniform.
• The gear mountings are not very rigid or accurate but contact across the full face of the gears will be obtained.
• The gear accuracy is not sufficient to assume that gear loads are shared among teeth.
• The gears operate at room temperature
a) What core hardness of the pinion is required in light of pinion tooth bending fatigue requirements?
b) What core hardness of the gear is required in light of gear tooth bending fatigue requirements?
c) What surface hardness of the pinion is required in light of pinion tooth surface fatigue requirements?
d) What surface hardness of the gear is required in light of gear tooth surface fatigue requirements?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

Engineering, 04.07.2019 18:20, xcapo1x

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

continue

You know the right answer?

A steel spur gear and mating pinion similar to those you have seen in class have 67 and 24 teeth res...