subject
Engineering, 08.09.2020 14:01 glydelxc2780

Suppose a knowledge base contains just the following first-order Horn clauses: Ancestor(Mother(x), x) Ancestor (z. У) Л Ancestor (y, z) Ancestor (1,2) Consider a forward chaining algorithm that, on the jth iteration, terminates if the KB contains a sentence that unifies with the query, else adds to the KB every atomic sentence that can be inferred from the sentences already in the KB after iteration j-1 (a) (12) For each of the following queries, say whether the algorithm will
(1) give an answer (if so, write down that answer); or (2) terminate with no answer; or (3) never terminate.
i. (3) Ancestor(Mother(v), John)
ii. (3) Ancestor(Mother(Mother(y)), John)
iii. (3) Ancestor(Mother(Mother(Mother(v))), Mother())
iv. (8) Ancestor(Mother(Johm), Mother(Mother(John) ))
(b) (3) Can a resolution algorithm prove from the original knowledge base that -Ancestor(John, John)? Ex plain briefly
(c) (3) Suppose the KB is augmented with the assertion that -(Mother(x)-), and that the resolution algorithm includes inference rules for equality. Now what is the answer to (b)'?

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, aliceohern
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
image
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
image
Engineering, 04.07.2019 18:10, katelynn73
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Suppose a knowledge base contains just the following first-order Horn clauses: Ancestor(Mother(x), x...

Questions in other subjects: