Engineering, 05.09.2020 01:01 kamal81
Which of the following is the reason why an engineer creates a model of something he or she plans to build? It is easier to modify smaller products than large ones. Exact dimensions are usually not available during the test phase. It is easier to store smaller-scale models than to have a full-scale project. It allows the engineer to test limitations in a controlled setting without the full-scale time and cost of the actual product.
Answers: 1
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20, luisgonz5050
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
Which of the following is the reason why an engineer creates a model of something he or she plans to...
Mathematics, 10.09.2020 07:01
English, 10.09.2020 07:01
Health, 10.09.2020 07:01
Mathematics, 10.09.2020 07:01
Mathematics, 10.09.2020 07:01
Mathematics, 10.09.2020 07:01
Mathematics, 10.09.2020 07:01
Mathematics, 10.09.2020 07:01
Mathematics, 10.09.2020 07:01
Mathematics, 10.09.2020 07:01