Engineering, 05.09.2020 01:01 raweber

A heat recovery steam generator is a type of heat exchaner in which thermal energy is used to produce steam. The Dell Children’s Medical Center in Austin, TX uses an HRSG to produce wet steam from the hot exhaust gases of the Solar Turbine Mercury 50 gas turbine engine. The hot exhaust gases (model as air) enter the heat exchanger at 700 °F and at a mass flow rate of 38.7 lbm/s. Saturated liquid water enters the heat exchanger at 80 psia where it is converted to saturated vapor by receiving heat from the hot exhaust gases. The HRSG has a 2nd Law efficiency (effectiveness) of 80%. For this heat exchanger determine:a) the temperature of the exhaust gases (air) leaving the heat exchanger (°F).b) the mass flow rate of steam produced (lbm/s).

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

Engineering, 04.07.2019 19:10, Destinationz

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

continue

You know the right answer?

A heat recovery steam generator is a type of heat exchaner in which thermal energy is used to produc...