Engineering, 03.09.2020 23:01 sis212

. Se desea determinar la proporción de hogares que tiene la costumbre de consumir carne de cerdo en una aldea de Zacapa. En un estudio piloto con
60 hogares de un total de 1130 se estimó que 45 de los hogares
entrevistados no acostumbran consumir carne de ninguna clase. ¿Cuál sería
del tamaño de muestra si quiere una precisión del 10% y un nivel de
confianza del 95%?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Engineering, 04.07.2019 19:10, netflixacc0107

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

continue

Engineering, 06.07.2019 05:10, j0162

The crank case of an automobile is 80 cm long 30 cm wide and 10 cm deep. find out the rate of heat flow from the crank case to the atmosphere when the automobile is moving at 90 km/hr. assume that the vibration of the engine and the chassis iaduce the transition from laminar to turbulent boundary layer may be considered over the entire surface. also find out the drag force on the total surface of the crank case. take the same average convective heat transfer coefficient and average shear stress for front and rare surfaces as for the bottom rnd sides crank case surface temperature is 75°c and atmospheric air temperature is 5 c

Answers: 2

continue

You know the right answer?

. Se desea determinar la proporción de hogares que tiene la costumbre de consumir carne de cerdo en...